125,000 BTU Radiant Tube Heaters

A 30x30 garage (900 sq ft) typically requires between 45,000 and 90,000 BTUs depending on insulation, ceiling height, and climate zone. A 125,000 BTU radiant tube heater would generously cover this space and is well-suited if the garage has poor insulation, high ceilings, or is located in a colder climate. Modulating models allow precise output control.

Power-vented heaters use a combustion air blower to push exhaust gases out, making them suitable for standard commercial installations. Vacuum-fired (Reflect-O-Ray EDS) systems use an exhauster to pull gases through the tube, allowing longer tube runs and greater design flexibility. Both types are available in 125,000 BTU configurations and are CSA certified.

Yes. All 125,000 BTU radiant tube heaters from Combustion Research Corporation are available for use with either natural gas (NG) or propane gas (LP). When ordering, specify the fuel type required so the unit is configured correctly at the factory. Field conversion kits may also be available through your representative.

Combustion Research Corporation provides a 10-year warranty on radiant tubes for internally created corrosion. Many models also include a 3-year warranty on ignition controls and electrical components. All units are 100% factory tested prior to shipment. Specific warranty terms may vary by model, so consult product documentation or your representative.

These heaters are widely used in aircraft hangars, large warehouses, service garages, auto dealerships, car and truck wash bays, greenhouses, pole barns, animal confinement facilities, natatoriums, shipping and receiving docks, and commercial or industrial spaces. Their ceiling-mounted design preserves floor space and eliminates forklift collision hazards common with ground-level heating equipment.

Yes. All radiant tube heaters from Combustion Research Corporation are CSA International Design Certified to ANSI/CGA standards and comply with ANSI Z83.20 / CSA 2.34. Every unit features 3-Try Direct Spark Ignition with 100% Safety Lockout, electronic flame monitoring, and a pre-purge cycle to meet applicable safety requirements for gas-fired radiant infrared heating equipment.